Your first steps with lil SOLID Ez​

1. Ensure the device is ON by pressing the button quickly and at the same time you can check the battery level.​

2. Slide the cover to open and insert a tobacco stick with the tobacco side into the device.​​

• Turn ON lil SOLID Ez, by pressing the ON/OFF button for 2 seconds until you feel a vibration​​.
• The device will pre-heat, while the light will blink ice blue for up to 25 seconds. ​
• When the pre-heating process comes to an end, the ice blue light is on, it vibrates again and is ready to be used.​​

3. Each experience lasts up to 5 mins or 14 puffs, whichever comes first.​

• The device vibrates and the light blinks ice blue to signal the last 3 puffs or 30 seconds.​

4. Once your experience has come to an end, twist the tobacco stick more than 3 times in the same direction, remove the heat stick and close the cover.​ ​

• Tobacco sticks specifically designed for lil™ are single use. Do not re-insert a used stick into the device.​ ​​

Watch the tutorial to learn more on how to use your lil SOLID Ez.​​

You can follow these easy steps to keep track of the battery:​

1. While charging, the status LED blinks, and the color of the LED indicates the level of the charge.​

2. When charged, the light turns solid blue.​

3. If the light blinks blue, your battery level is between 100-75%.​

4. If the light blinks ice blue, your battery level is between 75-35% - you still have some power.​

5. If the light blinks orange, your battery level is between 35-1% - you should charge.​

6. If the light blinks red, then you are out of battery and you need to charge.​


Watch the tutorial to learn more on how to charge your lil SOLID Ez.​

Follow these steps to clean your lil SOLID Ez for the best possible tobacco experience.​

​1. Always turn OFF your device before you clean it.​

2. Open the cleaning wiper from the dual cleaner.​

3. Remove the cap from the device.​

4. Use the cleaning wiper to clean the heating pin.​

5. Open the cap wiper from the dual cleaner.​

6. Use the cap wiper to clean the path for the aerosol​

Clean your device after every 20 experiences to guarantee proper aerosol delivery.​


​ You can also clean with heat:​

1. Quickly press the start button 5 times.​

2. The LED light will blink orange for 90 seconds.​

3. When the cleaning is done, the light goes off and you will feel the device vibrates twice.​

Watch the tutorial to learn more on how to clean your lil SOLID Ez.​